Lanner LEC-7920 Bedienungsanleitung PDF herunterladen (Seite 20)

Hardware Setup

Chapter 4

Embedded and Industrial Computing

Installing the Hard Disk

The system can accommodate one Serial-ATA disk. Follow

these steps to install a hard disk into the system:

Take out the hard disk tray and fix the hard disk on 1.

the tray with 4 mounting screws as illustrated in the

following picture.

Plug the Serial-ATA cable to the hard disk.2.

Place the hard disk back to the system’s chassis and fix 3.

it with the mounting screws.

Connect the Serial-ATA power and data disk cables to 4.

the Serial-ATA power and disk connectors on the main

board respectively.

Wall Mounting

The product ships with wall mounting kit. To mount your

product on the wall, follow the instructions below:

First make a hole for the anchor in the surface on the 1.

wall. Use the following diagram as a guideline for

placing the anchors.

Then press the anchor into the hole until it is flush with 2.

the surface. You may need a hammer to tap the wall

anchor.

Use a screwdriver to screw the threaded screw into the 3.

plastic anchor.

Attach the wall mounting bracket to the back of the 4.

device, securing it in place with four of the flat-head

screws provided.

Hang the device on the wall.5.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

Keine Kommentare

Lanner LEC-7920 Bedienungsanleitung Seite 20